Application of wake oscillators to two-dimensional vortex-induced vibrations of circular cylinders in oscillatory flows

A nonlinear time-domain simulation model for predicting two-dimensional vortex-induced vibration (VIV) of a flexibly mounted circular cylinder in planar and oscillatory flow is presented. This model is based on the utilization of van der Pol wake oscillators, being unconventional since wake oscillators have typically been applied to steady flow VIV predictions. The time-varying relative flow–cylinder velocities and accelerations are accounted for in deriving the coupled hydrodynamic lift, drag and inertia forces leading to the cylinder cross-flow and in-line oscillations. The system fluid–structure interaction equations explicitly contain the time-dependent and hybrid trigonometric terms. Depending on the Keulegan–Carpenter number (KC) incorporating the flow maximum velocity and excitation frequency, the model calibration is performed, entailing a set of empirical coefficients and expressions as a function of KC and mass ratio. Parametric investigations in cases of varying KC, reduced flow velocity, cylinder-to-flow frequency ratio and mass ratio are carried out, capturing some qualitative features of oscillatory flow VIV and exploring the effects of system parameters on response prediction characteristics. The model dependence of hydrodynamic coefficients on the Reynolds number is studied. Discrepancies and limitations versus advantages of the present model with different feasible solution scenarios are illuminated to inform the implementation of wake oscillators as a computationally efficient prediction model for VIV in oscillatory flows.     

Effects of van der Waals force on nonlinear vibration of electromechanical integrated electrostatic harmonic actuator

An electromechanical integrated electrostatic harmonic actuator is promising for the miniaturization of electromechanical devices. As the dimensions of the actuator decrease, the effects of the van der Waals force become obvious. In this study, by considering the nonlinearity of electrostatic and van der Waals forces, nonlinear vibration equations of the flexible ring of an electrostatic harmonic actuator are deduced. Using these equations, the nonlinear free vibration and nonlinear forced response of the actuator are investigated. The effects of the van der Waals force on the nonlinear vibration of the flexible ring are analyzed. Results show that these effects of the van der Waals force are relatively obvious under some conditions and should be considered.     

Validated Stability-Indicating GC-MS Method for Characterization of Forced Degradation Products of Trans-Caffeic Acid and Trans-Ferulic Acid

When dealing with simple phenols such as caffeic acid (CA) and ferulic acid (FA), found in a variety of plants, it is very important to have control over the most important factors that accelerate their degradation reactions. This is the first report in which the stabilities of these two compounds have been systematically tested by exposure to various different factors. Forced degradation studies were performed on pure standards (trans-CA and trans-FA), dissolved in different solvents and exposed to different oxidative, photolytic and thermal stress conditions. Additionally, a rapid, sensitive, and selective stability-indicating gas chromatographic-mass spectrometric method was developed and validated for determination of trans-CA and trans-FA in the presence of their degradation products. Cis-CA and cis-FA were confirmed as the only degradation products in all the experiments performed. All the compounds were perfectly separated by gas chromatography (GC) and identified using mass spectrometry (MS), a method that additionally elucidated their structures. In general, more protic solvents, higher temperatures, UV radiation and longer storage times led to more significant degradation (isomerization) of both trans-isomers. The most progressive isomerization of both compounds (up to 43%) was observed when the polar solutions were exposed to daylight at room temperature for 1 month. The method was validated for linearity, precision as repeatability, limit of detection (LOD) and limit of quantitation (LOQ). The method was confirmed as linear over tested concentration ranges from 1−100 mg L⁻¹ (r²s were above 0.999). The LOD and LOQ for trans-FA were 0.15 mg L⁻¹ and 0.50 mg L⁻¹, respectively. The LOD and LOQ for trans-CA were 0.23 mg L⁻¹ and 0.77 mg L⁻¹, respectively.     

某型电动飞机螺旋桨振动特性实验研究

某型电动飞机采用螺旋桨产生拉力,为了防止螺旋桨工作时共振,利用ES-2-150振动实验系统进行了两叶木质螺旋桨和碳纤维螺旋桨的振动特性实验,采用谐振搜索与驻留方法测量出木质螺旋桨的第一阶固有频率为36.07Hz,碳纤维螺旋桨的第一阶固有频率为73.58Hz。螺旋桨爬升状态转频为39Hz,这与木质螺旋桨的第一阶固有频率非常接近,导致木质螺旋桨在爬升状态出现比较严重的振动故障。因此,某型电动飞机最终选择两叶碳纤维螺旋桨作为其拉力产生装置。     

双稳态结构中的1/2次谐波共振及其对隔振特性的影响

以典型的双稳态系统——屈曲梁结构为例,基于等效模型,结合解析、数值和实验手段,研究了双稳态结构中的1/2次谐波共振特性、演化过程、参数调节规律及其对隔振特性的影响.研究发现,当非线性刚度系数或激励幅值增加到一定程度时,系统会在一定带宽下产生显著的1/2次谐波共振;随着激励幅值增加,阻尼系统的1/2次谐波遵循“产生-增强-衰退-消失”的过程,该过程对峰值频率和峰值传递率有重要影响;适当提高非线性强度能有效改善双稳态结构隔振特性.针对双稳态屈曲梁结构开展的实验验证了1/2次谐波特性和隔振特性变化规律.     

卫星振动对星间光码分多址系统性能的影响

卫星振动是影响星间光CDMA通信系统性能的一个重要因素.考虑多用户干扰、背景光噪音、热噪音、接收机噪音和卫星振动,给出了基于PPM信号格式的星间二维光CDMA通信系统的系统模型.采用数值分析的方法,详细分析了卫星振动对该系统误码率性能的影响.结果表明,码速率、通信波长和卫星振动都会影响星间二维光CDMA通信系统的误码率性能.当卫星振动标准偏差σ≤4×10－7时,卫星振动对系统误码率性能的影响较小；当卫星振动标准偏差σ≥1.2×10－6,卫星振动对系统误码率性能的影响很大,得到的误码率难以满足系统的通信要求,需要采用卫星振动抑制或补偿等技术提高星间二维光CDMA通信系统的误码率性能.     

微振动光电检测与数据采集系统的设计

提出了一种新的光学非接触式测量方法测量了物体的微振动振幅。用激光作为光源,以四象限硅光电池[1]作为光电探测器,借助三角测量原理,投射在振动源表面的激光反射光束在光电探测器上产生平面位移,将位移信号放大,通过A/D模块采集电压数值,并通过串口通信机制在PC终端实时显示。实验结果表明,该方法原理正确,灵敏度高,便于实现连续、快速、自动化检测,在工业在线检测方面具有良好的应用前景。     

Simulation of the nonlinear vibration of a string using the Cellular Automata based on the reflection rule

In this study, the nonlinear dynamic responses of a string are simulated using the Cellular Automata method based on the reflection rule. In the case of nonlinear systems, the velocity of wave propagation is not constant and depends on the amplitude. A new treatment of the dynamic time step is proposed for the Cellular Automata method considering the effect of the propagation velocity. As numerical examples, first, the dynamic responses of a string with linear characteristic are simulated using the Cellular Automata method. A typical resonance curve can be obtained. Second, the dynamic responses of a string with nonlinear characteristic are simulated using the proposed method. Some characteristic types of vibration can be obtained. It is concluded that the linear and nonlinear dynamic responses of a string may be obtained by simulation using the Cellular Automata method.     

用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。     

正交各向异性矩形板受迫振动的三维分析

从正交各向异性三维弹性动力学的控制方程出发，在求得四边简支矩形板自由振动频率和位移振型的基础上，构造了受迫振动的位移函数；利用自由振动位移振型的正交性，将控制方程的空间变量和时间变量分离，得到了广义质量、广义力和频率表示的关于时间的2阶常微分方程，从而得到了正交各向异性弹性矩形板在受迫振动下的位移场和应力场．给出了本文方法与薄板理论的算例．